Complete wiring harness for connecting 5 position lamps in the sunvisor. The harness replaces the original harness, that only has connectors for 2 lamps.
Updated model: Previous model was with single-conductor and crimped joint, while this new version is with double-insulated wires, and molded joint.
The connectors are placed so that there are one in each corner, and 3 closer together in the middle. If you need a special setup we can also do this.
There is a original Scania connector on the input, and original connectors for all the lamps. The connection is completely plug and play
The total length of the harness is 2100mm.
The harness is produced by Matronics
Accessory
Strain reliefs are available seperatly. They are clicked around the connector, and a cable tie is placed through the relief, and fastened around the wire. The cable tie must be max 2.5mm wide.
Special side-clamps with cable ties are available seperatly, for fastening the cable on the inside of the sunvisor.
Previously these were made with strain reliefs. As this is usually no necessary, they are not included any more.
Previously these were made with strain reliefs. As this is usually no necessary, they are not included any more.
Previously these were made with strain reliefs. As this is usually no necessary, they are not included any more.
Complete wiring harness for connecting 5 position lamps in the sunvisor. Replaces the original with connectors for only 2 lamps.
Vis fuld beskrivelse
